For a hard reset on a Samsung Galaxy S23, use Settings if the phone still opens; use Recovery mode only if you forgot the PIN, the buttons work, or the phone will not boot. A bad reset can erase data you meant to keep or leave you locked out by Factory Reset Protection. This guide shows when to choose each reset path and how to avoid verification and button-access problems.

What a hard reset means

On Samsung phones, people often use hard reset and factory reset to mean the same full wipe. On the Galaxy S23 family, that wipe returns the phone to factory state and removes the data stored on the device, so the right path matters before you start.

Samsung Support lists a factory reset FAQ for the Galaxy S23 support page, grouped under Backup & Restore. The support page also shows model identifiers such as SM-S911B/DS and SM-S911BZEGEUE, which helps confirm you are looking at the right device family.

Use a reset when the phone needs a clean start, you are passing it on, or a software problem is blocking normal use. Do not treat it as the first fix for every issue. If you still can open the phone, Settings is the cleaner route. If the phone is stuck, Recovery mode can be the fallback.

Which reset method should you use?

Which reset method should you use?
A person holds a Samsung Galaxy S23 with the side buttons highlighted

Pick the reset path by checking two things: whether the phone still opens, and whether you can get past the lock screen. Settings is best for a phone you can open. Recovery mode is for a phone that will not boot, is stuck on the Samsung logo, or cannot be reached through the normal menus.

Scenario Method Buttons/menus Data loss Common failure point
Normal reset Settings reset Settings > General management > Reset > Factory data reset Yes, all data on the phone is erased PIN, password, or lock confirmation is required
Forgotten PIN/password Recovery mode reset Power off, connect USB-C cable, hold Volume Up + Power, then choose Wipe data / Factory reset Yes, all data on the phone is erased Recovery does not appear or the phone was not fully powered off
Phone stuck on logo Recovery mode reset USB-C cable connected to PC or other USB-C device, then Volume Up + Power Yes, all data on the phone is erased Buttons do not reach Android Recovery
Button failure Settings reset if possible Use the Settings path while the phone is unlocked Yes, all data on the phone is erased Recovery cannot be entered without working buttons
Resale/trade-in prep Settings reset, then verify setup Remove accounts, then Factory data reset Yes, all data on the phone is erased Software locks or account checks can block the next owner

Say your Galaxy S23 Ultra still opens to the home screen but keeps freezing in one app. Settings is the safer choice because you can confirm the reset from inside the phone and finish the wipe without fighting Recovery mode.

Suppose a Galaxy S23 FE stops at the Samsung logo after a failed update. Recovery mode is the better path because the normal interface may never load, and the phone may need a wipe before it can boot again.

Can you reset from the Settings app?

Yes. If the Galaxy S23, S23+, S23 Ultra, or S23 FE still opens and you can open it, use the Settings path. Samsung may ask for your PIN, password, or another lock confirmation before the wipe starts, and that check is normal.

Use the Settings path

  1. Open Settings.
  2. Tap General management.
  3. Tap Reset.
  4. Choose Factory data reset.
  5. Review what will be erased, then confirm with your PIN, password, or screen lock.
  6. Start the reset and wait for the phone to finish.
  7. When the wipe ends, let the phone restart and go through setup again.

This path is the best answer to a normal factory reset request. It is also the most direct way to prepare a phone for handoff, because you can remove personal data before the wipe and then confirm the phone restarts into setup.

When Settings will not help

If you cannot open the device, the menu path stops at the lock screen. That is where many people get stuck. A forgotten PIN or password blocks the Settings route, and a failed screen lock check can leave the reset paused until you verify the device.

Need to use Recovery mode?

Need to use Recovery mode?
A Samsung phone displays the Android Recovery menu

Use Recovery mode when the phone will not boot, the Samsung logo will not move, or you cannot reach Settings. On the Galaxy S23 family, the button method typically requires the phone to be turned off first, and it is usually connected with a USB-C cable to a PC or other USB-C device before using the key combo.

Enter Android recovery

  1. Turn the phone off.
  2. Connect a USB-C cable to a PC or other USB-C device.
  3. Press and hold Volume Up and Power together until the device vibrates.
  4. Release the buttons when Android Recovery appears.
  5. Use the Volume keys to move through the menu.
  6. Press the Power key to confirm the selection.
  7. Choose Wipe data / Factory reset.
  8. Confirm the reset, then choose the reboot option when it appears.

Practical Tips says the recovery path starts with the phone powered off, and that the button combo is Volume Up plus Power. It also says the volume buttons move through the recovery menu, the power button confirms the choice, and the reset finishes by restarting the phone.

Recovery mode failures to watch

If Recovery mode never appears, recheck the power-off step first. Then confirm the USB-C cable is connected to a working PC or other USB-C device. If the phone still ignores the combo, the buttons may be failing or the device may need service.

Why the reset is blocked

Reset problems usually come from one of four places: account verification, a bad lock screen credential, a failed Recovery entry, or hardware that cannot register the buttons. The fastest first check is simple: make sure the phone is fully powered off, then try the correct reset path again.

Forgotten PIN or password

A forgotten PIN or password blocks the Settings route and can also make post-wipe verification harder later. The phone may ask for the same credential before the wipe starts, especially if security features are active.

  1. Try the Settings > General management > Reset > Factory data reset path only if you can unlock the phone.
  2. If you cannot unlock it, turn the phone off.
  3. Connect the phone to a USB-C cable linked to a PC or other USB-C device.
  4. Use Volume Up + Power to open Recovery.
  5. Choose Wipe data / Factory reset with the volume keys and Power key.

A phone stuck on the logo usually means the system is not loading far enough to reach Settings. Recovery mode is the next move, but only after the phone is off and connected by USB-C.

  1. Hold Power until the phone turns off.
  2. Connect a USB-C cable to a PC or other USB-C device.
  3. Hold Volume Up + Power until the device vibrates.
  4. If Recovery appears, use Volume to reach Wipe data / Factory reset.
  5. Press Power to confirm.

Volume or Power button failure

Broken buttons can block Recovery entry because the Galaxy S23 family depends on the hardware combo. If the buttons do not respond, the Settings path is the only normal reset route, and that still requires a phone you can open.

  1. Open Settings if the phone still runs.
  2. Go to General management > Reset > Factory data reset.
  3. Confirm the wipe with your lock screen credential.
  4. If the phone cannot be opened and the buttons fail, stop and get hardware help.

Account verification after the wipe

After a factory reset, the phone can still ask for account verification before setup continues. That risk is why you should sign out where possible and remove what you can before wiping, especially if the phone is going to someone else.

  1. Before the wipe, remove personal accounts where the phone allows it.
  2. Back up photos, messages, and files.
  3. Run the factory reset from Settings or Recovery.
  4. After restart, complete the setup with the same account details the phone expects.

If the phone still will not reset

If the first attempt fails, do not keep repeating the same step blindly. Move down the ladder: confirm the phone is fully off, try a different USB-C cable or host device, check whether Recovery responds to the buttons, and then decide whether the issue is software or hardware.

Try the next reset path

If Settings fails because of lock-screen verification, use Recovery mode. If Recovery fails because the combo does not appear, return to Settings only if the phone can be unlocked. One path often fails for a reason the other can bypass.

Check the cable and host device

The recovery method on the Galaxy S23 family depends on a USB-C connection to a PC or other USB-C device. If the device does not enter Recovery, swap the cable and try another host before assuming the phone is defective.

Get support if hardware is failing

If the buttons do not register, the screen is black, or the phone will not power off cleanly, software steps may not be enough. At that point, Samsung support or a repair shop is the sensible next stop.

Reset checklist for trade-in

For resale or trade-in, a factory reset is only part of the job. The next owner should not inherit your accounts, photos, messages, or software locks, and the phone should boot to the setup screen after the wipe.

  • Back up photos, messages, and files.
  • Remove the SIM card if you plan to keep it.
  • Handle eSIM removal through your carrier if needed.
  • Sign out of Samsung account and other accounts where possible.
  • Run Factory data reset.
  • After reboot, confirm the phone lands on the setup flow.
  • Check that personal information is gone before handing it over.

Trade-in rules vary by buyer, but the phone normally needs to be reset to factory settings with personal information removed and software locks cleared enough for the next owner to activate it. If a carrier or buyer lists a separate transfer step, follow that too.

Post-reset checks

After the wipe, the phone should restart and open the setup screens. Choose the language, connect to Wi-Fi, check for software updates if setup offers them, and restore from a backup only after you confirm the phone is working normally.

  1. Choose the correct language.
  2. Connect to Wi-Fi.
  3. Review any software update prompt during setup.
  4. Sign in to your account if you are keeping the phone.
  5. Restore from backup if you want your data back.

A common first-timer mistake is wiping the phone and then trying to remember whether the backup finished. Do the backup first, then reset, then restore. That order prevents a clean wipe from becoming a clean loss.

Keep reading

Frequently asked questions

Can't reset my Samsung phone

Start by checking whether the phone opens and is fully powered off. If the Settings path is blocked by a PIN or password, use Recovery mode with a USB-C cable and the Volume Up + Power combo. If the buttons or the screen are failing, hardware service may be the only path left.

How to reset Samsung phone without verification

If the lock screen verification blocks Settings, you generally need the Recovery path instead. Power the phone off, connect USB-C to a PC or other USB-C device, then open Android Recovery with Volume Up + Power. After the wipe, be ready for account verification during setup.